| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
FIGURE 3-67. Flywheel Housing Guide Studs.
(10)
Remove the remaining capscrews.
(11)
Use a rubber hammer to loosen the housing from the dowels in the cylinder block.
(12)
Remove the flywheel housing.
REPAIR
a.
Clean and inspect the flywheel as follows:
(1)
Use a wire brush to clean the crankshaft pilot bore.
(2)
Clean the flywheel with solvent, and dry with compressed air.
(3)
Visually inspect for nicks or burrs.
(4)
Use a fine crocus cloth to remove small nicks and burrs.
WARNING
Do not use a cracked or resurfaced flywheel. It can break, causing serious
personal injury or property damage.
(5)
Use crack detection kit to check for cracks in the flywheel. Follow the instructions provided
with the kit.
(6)
If cracks are found, replace flywheel assembly.
(7)
Inspect the flywheel ring gear teeth for cracks and chips.
3-116
|
||
|
||
