| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
(5) Rotate stator housing counterclockwise unil the voltmeter reading across output terminals is at a minimum level.
t
Make an identification mark on the end bracket adjacent to the mark on the permanent magnet stator housing.
(6) Rotate stator housing clockwise until voltmeter reading across output terminals is at a maximum level. Make an
identification mark on the end bracket adjacent to the mark on the permanent magnet stator housing.
(7) Reset permanent stator housing in the mid position between the two identification marks on the end bracket
.
(8) This setting will give a good starting point, but fine tuning between the two marks on the end bracket is necessary
to achieve the optimum setting for voltage response and voltage regulation.
(9) The permanent magnet stator is now positioned correctly for ideal voltage response and regulation. The clamp
washers should now be tightened and the position should be marked permanently with a punch or chisel on the
end bracket and permanent magnet stator housing.
4-26
|
||
|
||
