Custom Search
 
  
 
TM 55-1905-223-24-3
(a) Push the bushing in the bore until the oil holes in the bushings are aligned with the drillings in
the bore.
(b) Use a 0.094 inch (2.39 mm) diameter rod to check the position and the location of the oil holes
in the bushing and the cylinder block.
(c) The rod must pass through the oil holes in thebushing and into the oil supply drillings in the
cylinder block.
(9) Measure the camshaft bushings installed inside diameter. The measurement should be between
2.4983 inches (63.457 mm) and 2.5023 inches (63.558 mm).
d. Replace the gasket (8, Figure 4-47) as follows:
(1) Remove the six assembled washer screws (6, Figure 4-45) and remove the access cover (7).
(2) Remove the gasket (8).
(3) Position a new gasket (8) and install the access cover (7) with capscrews (6).
e. The pillow block (main bearing) caps (9, 11, 17, Figure 4-47) were removed with the crankshaft group
(paragraph 4-25). The pins (10) may be removed and replaced in the bearing caps.
4-113


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business