| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
h. Install hexhead capscrew (6), lockwasher (7) and secure angle bracket (8) to cylinder block.
i. Install new gasket (3), flange to hose elbow (2) and secure with six assembled washerscrews (1).
j. Install new nonmetallic hose (22) with hose clamps (23) and (21) on oil cooler assembly (9). Secure
hose clamp (21).
k. Install transfer tube (24) on nonmetallic hose (22) and secure hose clamp (23).
l. Install new nonmetallic hose (26) with hose clamps (25) and (27) on transfer tube (24). Secure hose
clamp (25).
m. Install nonmetallic hose (26) and hose clamp (27) on flange to hose elbow (2) and secure hose clamp
(27).
n. Connect turbocharger oil supply tube (4) and bypass filter return tube (13).
NOTE
Ensure there is a minimum of 0.250 inch (6.3 mm) clearance between the filter
and the oil pan flange of the cylinder block.
o. Install new preformed packing (14) and gasket (15) on fluid filter head (16) and install fluid filter head
(16) on oil cooler assembly (9) with flat washer (17), lockwasher (18) and assembled washerscrew
(19).
p. Fill new fluid filter element (20) with clean lubricating oil. Coat filter gasket sealing surface with clean
vegetable oil.
q. Install fluid filter element (20) by screwing clockwise by hand until snug.
CAUTION
Mechanical overtightening may distort the threads or damage the filter element seal.
r. Using oil filter wrench, tighten filter element (20) an additional three-fourths to one (3/4 to 1) turn.
s. Fill cooling system. Refer to TM 55-1905-223-10.
t. Startup engine. Refer to TM 55-1905-223-10.
u. Allow engine to run until water temperature reaches 180 (80 ).
F
C
v. Check for oil and coolant leaks. Repair as necessary.
w. Remove "Out of Service - Do Not Operate" tag.
2-96
|
||
|
||
