Custom Search
 
  
 
TM 55-1905-223-24-5
REPAIR
Repair consists of replacing preformed packing (7) and head gaskets (6).
REPLACEMENT
CAUTION
Ensure the gasket side marked TOP is up.
a. Install head gasket (6) on dowel pins (located in the block).
b. Place cylinder head (5) on engine block and align bolt holes with head gasket
(6).
c. Install two guide studs in the cylinder block for each cylinder head (5).
d. Install cylinder head (5) over the guide studs and dowel pins.
e. Remove guide studs.
f. Use clean oil and lubricate capscrews (3) and both sides of washers (4).
Allow excess oil to drain from capscrew threads.
g. Install capscrews (3) and washer (4); torque in the sequence shown in FIGURE
h. Tighten capscrews in stages to torque values below:
(1) Tighten to 25 ft-lb. torque.
(2) Tighten to 100 ft-lb. torque.
(3) Tighten to 285 ft-lb. torque.
i. Install preformed packing (7).
j. Install fuel crossover connection (1).
k. Install fuel crossover bolts (2). Tighten to 35 in-lb torque.
2-149


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business