Custom Search
 
  
 
TM 55-1905-223-24-5
(11) Use a rubber hammer to loosen the housing from the dowels in the cylinder block.
(12) Remove the flywheel housing.
(13) Remove electrical coil from the top at flywheel housing.
REPAIR
Repair is by replacement of flywheel, rear crankshaft seal, gaskets and electrical coil.
REPLACEMENT
a. Flywheel housing redowel to cylinder block.
(1) Use dowel pin extractor (2, FIGURE 3-83) and remove the two dowel pins (1) from cylinder block.
b. Install the flywheel housing, as follows:
CAUTION
If a new flywheel housing is being installed, the dowels must be removed from
the cylinder block prior to installing the housing to prevent damage to the
housing. The housing must be doweled with an oversize dowel after it has been
aligned.
NOTE
If the dowel pins were removed from the cylinder block, use a drill and
reaming fixture to ream the dowel holes to the next oversize.
Install the dowel pins. The dowels must be even with or 0.010 inch (0.25
mm) below the surface of the housing that is closest to the flywheel.
(1) Install two 5/8-18 x 4 inch guide studs (FIGURE 3-86) in the cylinder block to help support and align
the housing during installation (FIGURE 3-87) .
(2) Install the flywheel housing over the guide studs.
(3) Install the capscrews, and tighten to 150 ft-lb (205 N ) torque in the sequence shown (FIGURE 3-
m
88) .
(4) Measure the flywheel housing bore alignment.
3-126


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business