CHAPTER 4 INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Custom Search

SECTION VI. PREPARATION FOR STORAGE OR SHIPMENT

TM-55-1905-223-24-5 Bowthruster Engine for Landing Craft Utility (LCU) NSN 1905-01-154-1191 Manual

SECTION II. SERVICE UPON RECEIPT

TM 55-1905-223-24-5

CHAPTER 4

INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Section I.

Repair Parts, Special Tools; Test, Measurement, and

Diagnostic Equipment (TMDE); and Support Equipment ...................................... 4-1

Section II.

Service Upon Receipt .......................................................................................... 4-1

Section III.

Intermediate General Support Preventive Maintenance

Checks and Services (PMCS). ............................................................................. 4-2

Section IV.

Intermediate General Support Troubleshooting Procedures.................................. 4-2

Section V.

Intermediate General Support Maintenance Procedures....................................... 4-5

Section VI.

Preparation for Storage or Shipment ................................................................... 4-113

SECTION I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,

AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

4-1. Common Tools and Equipment . For authorized common tools and equipment, refer to the Modified

Table of Organization and Equipment (MTOE) applicable to your organization.

4-2. Special Tools, (TMDE), and Support Equipment. For special tools, test, measurement, and diagnostic

equipment; and support equipment, requirements are listed and illustrated in the Repair Parts and Special

Tools List (RPSTL), TM 55-1905-223-24P. These items are also listed in the Maintenance Allocation Chart

4-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),

TM 55-1905-223-24P.

SECTION II. SERVICE UPON RECEIPT

4-4. Checking and Deprocessing Unpacked Equipment.

a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,

report the damage in accordance with the instructions of DA Pam 738-750.

Check the equipment against the packing slip to see if the shipment is complete.

Report all

discrepancies in accordance with the instructions of DA Pam 738-750.

c. Check to see whether the equipment has been modified.

d. Remove protective caps, plugs, inserts, wrappings, and tape when inspection/inventory is completed.

Inspect piping openings for damage. Wipe off dirt, grease, or protective films at time of installation.

e. Remove chocks from resilient mounted components.

4-1