| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
FIGURE 4-52. Bearing Cap Location Marks.
(11) Install the main bearing caps as follows:
(a) Align the capscrew holes in the cap with the holes in the cylinder block. Make sure the ring dowel
and the lower bearing shell are in position.
(b) Install the capscrews and the washers through the cap and into the cylinder block.
(c) Use your hand to tighten the capscrews two to three threads.
CAUTION
When hitting the cap, make sure the bearing shell and dowel ring do not move.
(d) Hit the cap with a rubber mallet to push it into the correct position.
(12) Tighten the capscrews on a main bearing cap on engines built with 1-inch diameter main bearing
capscrews to the following torque values:
(a) Tighten both to 110 ft-lb.
(b) Tighten both to 210 ft-lb.
(c) Tighten both to 310 ft-lb.
(d) Loosen both completely.
(e) Tighten again as described above.
Change 2
4-95
|
||
|
||
