Custom Search
 
  
 
TM 55-1905-223-24-5
FIGURE 4-53. Bearing Cap Torque Sequence.
(d) Measure the crankshaft end clearance.  The end clearance specification for a new or reground
crankshaft with new thrust bearings is 0.07 inch (0.18 mm) to 0.018 inch (0.45 mm).
NOTE
Crankshafts that have been reground on the thrust bearing surfaces
are marked for oversize thrust bearings on the rear crankshaft
counter weight. If the crankshaft counter weight is marked, check the
thrust ring part number to make sure the correct thrust ring size is
FIGURE 4-54. Example of Oversize Thrust Bearing Marks.
4-97


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business