| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
a. Replace the cylinder sleeve set as follows:
(1) Remove the liner (4, FIGURE 4-55) .
DISASSEMBLY
a. Unless otherwise directed, remove the following:
(1) Cam follower assemblies (paragraph 3-18).
(2) Camshaft (paragraph 3-24).
(3) Connecting rod and piston group (paragraph 3-25).
b. Through the process of removing the assemblies and components listed in the Equipment Conditions
in Step (a), the block assembly should now be free from its mounts and supported by the lifting
fixture.
NOTE
Other external components or fixtures may have to be moved, or.
removed, to provide necessary clearance for removing the block
assembly.
CAUTION
The liner puller must be installed and used as described to avoid
damage to the cylinder block.
(1)
(a) Insert the liner puller (FIGURE 4-56) in the top of the cylinder block.
1 The liner puller must be centered on the top of the cylinder block.
2 When using liner puller shown in FIGURE 4-56 the feet on the extension
arms must be extended below the bottom of the liner.
3 With liner puller shown in FIGURE 4-56, the puller plate must be
parallel to the main bearing saddles and it must not overload the liner
outside diameter.
(b) Turn the puller jackscrew clockwise.
(c) Use both hands to remove the liners.
(d) Remove and discard the performed packing (2, FIGURE 4-55) and gasket
(3).
NOTE
Do not discard the shims (5, FIGURE 4-55) which may be used under
the cylinder liner flange.
4-99
|
||
|
||
