| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-6
d.
Remove the bearing assembly cross (14).
e.
At the other end of the drive shaft, remove two retaining rings (17) from the shaft yoke (19).
f.
Remove both bearing caps (18) out of the flange yoke (4).
g.
Remove both bearing caps out of the shaft yoke (19) and remove the flange yoke.
h.
Remove the bearing assembly cross (16).
_______
REPAIR
a.
Using solvent, clean all parts and wipe dry.
b.
Replace all parts showing deformation, corrosion, or other signs of unserviceability.
__________
ASSEMBLY
a.
Install the bearing assembly cross (16) into the flange yoke (4).
b.
Install flange yoke (4) into shaft yoke (19) and install bearing caps.
c.
Install retaining rings (17).
d.
Install bearing caps (18) on flange yoke (4) and install retaining rings (17).
e.
Install the bearing assembly cross (14) into the flange yoke (9).
f.
Install flange yoke (9) into shaft yoke (11).
g.
Install bearing caps (12) on flange yoke (9) and install retaining rings (13).
_____________
REPLACEMENT
a.
Position drive shaft (5) between engine and bowthruster waterjet.
b.
Align the forward end of the drive shaft (5) with the waterjet flange (10). Secure flange yoke
(9) to waterjet flange (10) with eight bolts (8), lockwashers (7), and nuts (6). Torque nuts (6)
alternately to 48 ft-lb.
|
||
|
||
