| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-9
ASSEMBLY
NOTE
Lubricate parts with clean hydraulic fluid during installation.
a. Shuttle Valve and Relief Vent.
(1) Install preformed packing (46) and pipe plug (45) into relief vent (44).
(2) Install relief vent (44) into uniblock body (47).
(3) Install pipe plug (43) and preformed packing (41, 42).
(4) Install ball cup (38), ported valve ball (26), preformed packing (7, 25), shuttle screw (40), and pipe plug
(24).
(5) Install relief valve body (37), preformed packing (36), ported valve ball (27), ball cup (28), spring (29),
preformed packing (30), seal washer (35), adjusting screw (32), flat washer (34), self-locking nut (33), and
wire (31).
(6) Secure shuttle valve body (39) to uniblock body (67) with lockwasher (14) and machine bolt (23).
b. Filters.
(1) Inlet Filter.
(a) Install inlet filter (22).
(b) Install retaining disk (21), machine screw (17), and preformed packing (20).
(2) Outlet Filter.
(a) Install outlet filter (19).
(b) Install retaining disk (18), machine screw (17), and preformed packing (16).
(c) Install ported ball valve (9), spring (10), preformed packing (7, 12), plug (11), and pipe plug (8).
(d) Install end plate (13).
(e) Secure end plate with lockwasher (14) and machine bolt (15).
3-20
|
||
|
||
