| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0134 00
REMOVAL--SINK TRAP
1.
Position a suitable drain pan beneath the sink trap (4).
2.
Remove the drain plug (5) from the sink trap (4) and allow the sink trap to drain into the drain pan.
3.
Loosen the two trap nuts (6) and remove the sink trap (4).
INSTALLATION--SINK TRAP
1.
Position a new or cleaned sink trap (4) into the piping (7) and secure it by tightening the two trap nuts (6).
2.
If not already installed, install the drain plug (5) into the sink trap (4).
3.
Pour fresh water into the sink and check for leakage at the sink trap.
4.
Dispose of the water in the drain pan by pouring it down the drain.
WARNING
Sewage is a common mode of transmission for parasitic organisms that may have the
capability of causing communicable diseases. Protective gloves and a protective apron
should be worn to help prevent contact with sewage. After coming in contact with
sewage or contaminated equipment, be sure to clean yourself with a disinfectant soap.
Avoid sewage contact with skin abrasions, punctures, cuts, and other open wounds.
Wipe up and clean any spills and/or contaminated equipment using a disinfectant soap.
Failure to comply could result in illness, serious injury, or death.
REMOVAL--MISCELLANEOUS PIPING
1.
Position a suitable drain pan beneath the area of repair.
2.
Loosen the union (8) at one end of the piping section that contains the component that will be replaced.
3.
Loosen the union (8) at the other end of the piping section that contains the component that will be replaced and remove
the piping section.
4.
Disassemble the piping section as necessary to remove the pipe (9) or fitting (10) to be replaced.
0134 00-2
|
||
|
||
