| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0164 00
CLEANING
1.
Don chemical protective gloves and goggles.
2.
Clean all the parts in cleaning solvent and wipe dry with clean wiping rags.
ASSEMBLY
1.
Assemble the spring (13), spring seat (12), new filter element (11) and new preformed packing (10) in the filter
housing (9).
2.
Install the cap (8) into the filter housing (9) and tighten it snugly.
INSTALLATION
1.
Wrap the pipe thread end of the male connector (7) with antiseizing sealant tape.
2.
Install the male connector (7) into the inlet port of the filter housing (3).
3.
Wrap the pipe thread on the reducing hex nipple (5) with antiseizing sealant tape.
4.
Thread the filter housing (3) onto the reducing hex nipple (5).
5.
Secure the filter housing (3) to its mount with the U-bolt (2) and nuts (1).
6.
Connect the hose (4) to the male connector (7) on the inlet side of the filter housing (3).
7.
Remove the lockouts and tagouts and check the operation of the system, ensuring that the hydraulic starter turns the
engine properly and that no leaks exist.
8.
Check the level of hydraulic fluid in the reservoir and replenish it as necessary.
9.
Dispose of used hydraulic fluid, used cleaning solvent, and contaminated materials in accordance with local regulations.
END OF WORK PACKAGE
01640164 00-3
00-3/4 blank
|
||
|
||
