TRANSMISSION - LO-55-1905-222-120006

Custom Search

FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW -10

LO-55-1905-222-12 Landing Craft Mechanized (LCM-8) (ROHR and Gunderson Models) (1905-01-284-2647 AND 1905-01-284-2649) Manual

ENGINE CONTROLS

LO 55-1905-222-12

NOTES:

16. TRANSMISSION. Start engine and let run until warm (160185 ). Check transmission oil level daily with engine

running at idle speed (550 RPM) and transmission in neutral. Fill transmission with oil, OE/HDO, up to FULL mark on

dipstick.

17. TACHOMETER DRIVE CABLE ADAPTER. Lubricate grease fitting with two shots of MPG grease.

18. TRANSMISSION OIL FILTER AND STRAINER. Start engine and let run until warm (160185 ). See note 21.

Drain oil from transmission reservoir.

a. Filter. Remove filter element and install new element and new gasket and o-ring.

b. Strainer. Remove strainer and discard gasket. Clean strainer and inspect. Replace if defective. Install strainer

and new gasket.

c. Fill transmission reservoir with 24 quarts (22.7 liters) of OE/HDO. Operate engine and check for leaks. Check

transmission oil level per note 16.

19. OVERSPEED GOVERNOR. Do not lubricate the overspeed governor while the engine is operating.

Avoid

excessive lubrication. Add 5 or 6 drops of OE/HDO to hinge-type cap oiler or oil cups.

20. ENGINE OIL FILTERS. Start engine and let run until warm (160185 ). See note 21. Drain oil from crankcase.

Drain oil from filters into suitable container. Install filter drain plug with new gasket if necessary. Remove filter

elements, clean adapter and install new elements. Fill crankcase with 40 qts (37.9 liters) of OE/HDO. Operate engine

5 minutes. Check for leaks. Wait 5 minutes after engine shut down, check crankcase oil level and bring to FULL mark.

LUBRICANT INTERVAL

INTERVAL LUBRICANT

MAIN PROPULSION ENGINE

VIEW, LOOKING DOWN

Card 6 of 8