| Tweet |
Custom Search
|
|
|
||
 LO 55-1905-223-12
Notes:
37. Recheck oil level during first few hours of operation.
38. Grease daily when in use. Use hand held lubrication gun. Apply until fresh grease exudes from bearing. Wipe off
excess.
39. Five strokes of grease from hand lubricating gun at outboard drum bearings.
40. Clean and apply a light coat of silicone lubricant to slack wire limit switch and interlock switch.
41. Emergency hand crank, remove housing and apply a light coating of grease by hand or with a small brush to the
ratchet dog and ratchet wheel teeth.
CAUTION
Do Not Contaminate Friction Discs With Grease.
42. Gear reducer. Remove plug at 6 o'clock position on reducer case and drain reducer completely. Refill with
lubricant.
WARNING
When applying grease to wire rope by hand, broken strands of wire can cause injury to
personnel. Use approved gloves.
43. Apply grease evenly with small brush or by hand.
44. Open drain valve(s) and drain reservoir(s). Close drain valve(s). Remove fill cap(s) and fill reservoir(s) to the HIGH
mark on sight gauge(s) with hydraulic fluid.
LUBRICANT INTERVAL
INTERVAL
LUBRICANT
M
GAA
Chain Stopper Tongue
Axle Grease Fittings
2 Places (See Note
45) (C)
Sheave Assemblies GAA
Grease Fittings
M
GAA
Wildcat Sheave Grease
6 Places
M
Fittings, 2 Places
(See Note 45)
(See Note 45) (C)
(C)
GAA
Locking Bar and
M
Ratchet Dog, 2
Places (See Note
45) (C)
M
GAA
Locking Bar Axle
Grease Fittings, 2
Places (See Note
45) (C)
M
BOW RAMP
GAA
Main Hinges Grease
Fittings, 2 Places
(See Note 45) (C)
TOTAL TASK-HOURS*
INTERVAL
TASK-HOURS*
M
1.5
-KEY-
EXPECTED TEMPERATURES
CAPACITY
INTERVALS
ALL TEMPERATURES
GAA
As Required
Grease
M-Monthly
Grease
(MIL-PRF-10924)
45. Grease daily when in use. Use hand held lubrication gun. Apply until fresh grease exudes from bearing.
Card 15 of 41
|
||
|
||
