| Tweet |
Custom Search
|
|
|
||
 FOLD
FOLD
-KEY-
EXPECTED TEMPERATURES
Above + 32F
+ 40to - 10F
0F to - 65F
LUBRICANTS
CAPACITY
INTERVALS
OEHDO-LUBRICATING OIL, Engine
Crankcase Model 3061A
15 qts
Intervals
Model 4061 A
17 qts
OE/HDO 30
OE/HDO 10
OES
given are
Oil Con Points
in hours of
OES-LUBRICATING OIL, Sub-zero
normal
GAA-GREASE, Auto & Artillery
operation
ALL TEMPERATURES
NOTES:
1. FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD
6. LUBRICANTS: The following is a list of lubricants with the Military
Symbols and the applicable specification numbers.
TEMPERATURES BELOW - 10F. Remove lubricants prescribed in the
key for temperatures above -10 . Relubricate with lubricants specified in
F
OE/HDO MlL-L-2104C
OES MIL-L-10295
GAA MIL-G-10 924
the key for temperatures below - 10 F.
Copy of this Lubrication Order will remain with the equipment at all times;
2.
OIL LEVEL SIGHT GAGE. Add oil when necessary.
instructions contained herein are mandatory.
3. PRIMING PUMP. Check oil level every 10 hours. Remove the filler
BY ORDER OF THE SECRETARY OF THE ARMY
plug which carries an oil gage in a recess. Place the oil gage in the oil fill
CREIGHTON W. ABRAMS
plug hole and check oil level. Keep oil at high level mark, use OE/HDO
General, United States Army
10, replace plug.
Chief of Staff
4. FRESH WATER PUMP. Bearings are permanently sealed and
lubricated for the life of the bearing.
OFFICIAL:
5. CRANKCASE DRAIN. Remove plug and drain. Replace plug and
VERNE L. BOWERS
Major General, United States Army
refill crankcase with proper grade OE/HDO to full mark on oil gage.
The Adjutant General
DISTRIBUTION: To be distributed in accordance with DA Form 12-
25D (qty rqr block No. 813) Operator' Maintenance requirements
s
for Marine Equipment: All.
L055-1925-204-12-5
U.S. GOVERNMENT PRINTING OFFICE: 1973 O-519-798
|
||
|
||
