| Tweet |
Custom Search
|
|
|
||
 KEY
LUBRICANTS
CAPACITY
EXPECTED TEMPERATURES
INTERVALS
Above +32
F
+40 to -10
F
F
0 to 65
F
F
OE-Oil, Engine, Heavy Duty
OE 10
Starting Motor Lubrications
1.4 qt ea
OE 10
Intervals
Oil Can Points
OES
given are in
OES-Oil, Engine, Sub-zero
hours of
Wheel Column
35 gal ea
GO 90
GO 80
GOS
normal
WRT-GREASE, Aircraft General Purpose
operation
Wheel Spindle Grease Retainer 4 ea.
ALL TEMPERATURES
GLA-GREASE, Automotive and Artillery
NOTES:
1. FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD
for presence of water in wheel and wheel column only after wheel has not
TEMPERATURES BELOW -10 . Remove lubricants prescribed in the
F
moved during preceding 1/2 hour.
key for temperatures above -10 . Relubricate with lubricants specified in
F
the key for temperatures below -10 .
F
6. TRANSMISSION-TORQUE CONVERTER OIL FILTER. Every 500
2. AIR STARTING MOTOR LUBRICATOR. Adjust lubricator to meter
hours, remove filter, clean housing and filter bag. Reassemble, operate
one drop per second into sight feed dome. This will allow three drops per
until warm. Check for leaks, check level and bring to full mark.
minute into the air line.
3. MARINE GEAR OIL FILTER. Every 500 hours, remove filter, clean
7. PROPELLER STERN TUBE BUSHINGS. Every 10 hours and after
housing and element, reinstall filter. Operate until warm. check for leaks,
each amphibious operation lubricate with WTR. Substitute GAA grease
metal contamination and for presence of water.
when the temperature is expected to drop below zero degrees F. When
water based, lubricate bushing each watch.
4. RAMP CONTROL CABLE. Every 50 hours clean and coat cables with
OE oil.
8. LUBRICANTS. The following is a list of lubricants with the Military
5. WHEEL COLUMN AND WHEEL BEARINGS. Every 10 hours rotate
Symbols and the applicable specification numbers.
wheel until plug is horizontal with center line of axle. Remove plug, check
level. Every 500 hours, rotate wheel until plug is at bottom center, remove
OE MIL-L-2104
OES MIL-L-10295
GAA MIL-G-10924
plug and drain, reinstall plug. Rotate wheel back to level point, fill. Check
GO MIL-L-2105
GOS MIL-L-10324
MTR MIL-G-81322
TS 015528
Card 4 of 10
|
||
|
||
