| Tweet |
Custom Search
|
|
|
||
 TB 600-1
SECTION X
PART III
ELECTRIC START A 5KW GENERATOR SET AND PERFORM DURING OPERATION CHECKS
PERFORMANCE MEASURES
+(Not scored in sequence)
PASS
FAIL
*1.
Circuit Breaker. Place circuit breaker in the OFF position.
____
____
2.
Operating Levers and Controls. Insure that all operating levers and controls are in
the proper operating positions.
____
____
*3.
Voltage Phase Output Selector Switch, or change board. Position the output
selector switch in accordance with the output voltage and phase requirement.
____
____
+ = Not scored in sequence but must be completed prior to
beginning the scored in sequence performance measures.
(Scored in sequence)
*1.
Starting Instructions. Use TM 5-6115-332-4 to prepare for starting and to start
5KW generator set.
____
____
*2.
Fuel Selector Valve. Place fuel selector valve in the proper position, depending on
source of fuel.
____
____
*3.
Oil Pan Baffle Rod. Place oil pan baffle rod in the proper position, depending on
ambient temperature.
____
____
*4.
Air Cleaner Intake Shutter. Place air cleaner intake shutter in the proper position,
depending on ambient temperature.
____
____
*5.
Governor Control. Position governor control in govern position
____
____
*6.
Remote-Local Switch. Place remote-local switch in the local position.
____
____
*7.
Emergency Run-Stop Switch. Place emergency run-stop switch in the normal
____
____
position.
*8.
Ear Protection. Ear plugs or ear headset will be in place at this time.
____
____
*9.
Start-Stop Switch. Push the start-stop switch to the start position. Hold until
engine has started and 15 to 20 psi shows on the oil pressure gage.
____
____
Change 3 H-35
|
||
|
||
