| Tweet |
Custom Search
|
|
|
||
 TM 11-5895-1847-12&P
0120 00
{1} Remove small knob (15), felt washers (16) and PVC washers (17) from both sides of the 9701 console
(1) and the mount bracket (18).
{2} Loosen large knob (19) on both sides of the 9701 console (1) and the mount bracket (18).
b.
Tilt the 9701 console (1) approximately 25 deg angle. Place a wedge (block of wood) (20) between the 9701
console (1) and the mount bracket (18) to keep the console tilted at this angle.
c.
Tighten large knob (19) on both sides of the 9701 console (1) and the mount bracket (18) to keep the
console (1) tilted during disassembly.
d.
Remove top cover (14).
{1} Remove 13 screws (21) that secure top cover to 9701 console (1).
{2} Remove top cover (14).
13. Remove MF/HF DSC watch receiver (22).
a.
Remove eight mounting screws (23) from front of MF/HF DSC watch receiver faceplate (24).
b.
Loosen two captive fasteners (25) (one each side of MF/HF DSC watch receiver) that secure the MF/HF DSC
watch receiver (22) to the mounts on the inside of the 9701 console (1).
22
A
NN
TE S
ANOHM
50
4
3
2
26
1
P4
US
AB
SE
00
70
A
SE
P3
32
US
30
32
AB
28
R2
SE
RS
30
7
A3
DB
SE
P2
CH
29
AT
AW
SE
01
70
A
SE
S/N
31
27
2C108-3
c.
Disconnect antenna coaxial connector (26) from antenna receptacle on back of MF/HF DSC watch
receiver (22).
d.
Disconnect P2 connector (27) from back of MF/HF DSC watch receiver (22).
CAUTION
When disconnecting the P2 and P3 connectors from the back of the MF/HF DSC watch
receiver, use extreme caution. Pull the connectors straight out. Do not twist or turn the
connector in any way. Do not break or damage any wires attached to the connectors.
Failure to comply could result in equipment/connector damage and/or failure.
{1} Grasp the connector (27) and pull straight outward to disconnect.
0120 00 3
|
||
|
||
