| Tweet |
Custom Search
|
|
|
|
||
|
||
 0156 00
TM 11-5895-1847-12&P
b.
Remove rubber tape.
c.
Repeat if necessary to expose connector.
REPLACE ANTENNA CONNECTOR WATERPROOFING
NOTE
Ensure that the connection is secured and that the cable is secured in the connector.
1.
Wrap rubber tape around cable (1), approximately one inch below the edge of the outer insulation (2), stretching
the tape tightly.
2.
Continue wrapping rubber tape around cable (1) and connector (3), stretching tightly to make a tight seal, and
overlapping the previous layer by approximately 75%.
3.
Cut rubber tape with knife.
4.
Apply a second layer of rubber tape (4) by repeating steps 1, 2, and 3.
5.
Apply electrical tape around cable (1) approximately one inch below the edge of the rubber tape stretching the
tape slightly.
6.
Continue wrapping electrical tape around cable (1) and connector (3), stretching slightly, and overlapping
previous layer by approximately 50%.
7.
Apply a second layer of electrical tape (5) starting at the connector and working towards the cable.
8.
Continue past the first layer approximately one inch. The final three wraps should not be stretched in order to
prevent unravelling.
9.
Cut tape with knife.
10. Wrap rubber tape around cable (1) and antenna, stretching the tape tightly.
11. Cut rubber tape with knife.
12. Wrap electrical tape around antenna and cable (1), stretching slightly, over rubber tape. Overlap previous layer of
tape by approximately 50%.
13. Cut electrical tape with knife.
0156 00 2
|
||
|
||
