| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
NOTE
Insert not used on some rubber molding.
1.
Using putty knife, remove rubber molding insert (1) from window molding (2) (located on outside of cab).
2.
Using putty knife, start at corner of windshield panel (3) and pry panel loose from rubber molding (2).
Remove rubber molding (2).
3.
4.
Discard rubber molding (2) and rubber molding insert (1).
INSTALL:
1.
Measure and cut rubber molding insert (1) and rubber molding (2) to proper length.
2.
Using soap and water solution, wet new rubber molding.
Install rubber molding (2) onto windshield panel frame (4) with slot for insert (1) located on outside of windshield (3).
3.
4.
Install new windshield panel by starting in one comer of frame (4) and applying sufficient force to seat panel (3) Into
rubber molding (2).
NOTE
Insert not required with some rubber molding.
Install new rubber molding insert (1).
5.
Reposition windshield wiper blade and arm.
6.
Install cab assembly (refer to paragraph 3-10).
7.
3-12
|
||
|
||
