| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
1.
Using two 13 mm sockets, two ratchets and two extensions remove four bolts (1), washers (2), and nuts (3) securing
rub rail section (5) to pushknees (4).
2.
Remove fender (rub rail) sections (5) and metal insert (6).
INSTALL FENDER (RUB RAIL):
1.
Lay metal insert on flat side of new rub rail and mark hole locations.
2.
Using electric drill and 1/2 inch bit, drill 1/2 inch holes through flat side of rub rail.
Using electric drill and 1-1/4 inch hole cutter, cut holes through rub rail opposite 1/2 inch holes.
3.
4.
Install metal insert into rub rail section.
5.
Using two 13 mm sockets, two ratchets and two extensions install four bolts (1), washers (2), and nuts (3) securing
rub rail section to pushknees.
REMOVE BRACES:
1.
Using 3/4 inch socket, ratchet and 3/4 inch box wrench remove two bolts (7), two washers (8) and two nuts (9).
2.
Remove braces (10).
INSTALL BRACES:
1.
Place braces (10) in position with bolt holes alined with brackets on pushknee and hull.
2.
Install two bolts (7), two washers (8) and two nuts (9) using 3/4 inch socket, ratchet and 3/4 inch box wrench.
3-36
|
||
|
||
