| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
1.
Using two 13 mm sockets, two ratchets and two extensions remove five bolts (1), washers (2), and nuts (3) securing
rub rail section (5) to pushknees (4).
2.
Remove fender (rub rail) sections (5) and metal insert (6).
INSTALL FENDER (RUB RAIL):
1.
Lay metal insert on flat side of new rub rail and mark hole locations.
2.
Using electric drill and 1/2 inch bit, drill 1/2 inch holes through flat side of rub rail.
3.
Using electric drill and 1-1/4 inch hole cutter, cut holes through rub rail opposite 1/2 inch holes.
4.
Install metal insert into rub rail section.
5.
Using two 13 mm sockets, two ratchets and two extensions install five bolts (1), washers (2) and nuts (3) securing
rub rail section to pushknees.
3-40
|
||
|
||
