| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
1.
Open battery hatch (1) to half open position.
2.
Remove 12 nuts (2), sixteen washers (3) and 12 bolts (4) from three hinges (5). hatch (6) and boat frame (7) using
two wrenches.
3.
Remove hinges and battery hatch.
4.
Using two wrenches remove nut (8), washer (9) and bolt (10) securing battery hatch support brace (11) to boat frame.
5.
Remove support brace.
1.
Install strip of adhesive rubber seal (12) around inside of battery hatch.
2.
Replace support brace.
Using two wrenches install washer (9), bolt (10) and nut (8) securing support brace (11) to boat frame.
3.
4.
Fit new hinge assembly (5) to boat frame and aline holes.
Install four bolts (4) and eight washers (3) through three hinge assembly and boat frame. Attach eight washers (3)
5.
and four nuts (2) and tighten using two wrenches.
Position new battery hatch (1) over battery compartment (insure hinge mounting holes are aft) then raise to half open
6.
position.
Aline hinge holes with holes in battery hatch.
7.
8.
Install four bolts (4) and eight washers (3) through three hinge assemblies and battery hatch cover. Attach eight
washers (3) and four nuts (2) and tighten using two wrenches.
Open and secure battery hatch (refer to paragraph 3-154).
9.
10.
Close battery hatch.
3-42
|
||
|
||
