| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
The cables should NOT be bent sharply in any direction. Severe cable damage
may result.
NOTE
Transmission control head assembly is identical to engine control head assembly except
for detent plate.
REMOVE:
1.
Open access panel under control console (refer to paragraph 3-154).
2.
Using screwdriver and 3/8 inch open end wrench remove four nuts (2), washers (3) and bolts (1) securing control
head to console.
Using 3/8 inch open end wrench remove cable damps (4) from control head side plates (17).
3.
4.
Pull control head out of console as far as attached cables will allow.
5.
Using pliers remove cotter pins (5) securing cable pivots (8).
Using Allen wrench loosen socket head screw (6).
6.
7.
Move linkage plates (7) as required to allow clearance for cable pivots.
Remove cable pivots (8).
8.
Lift engine control head assembly (9) out of console.
9.
10.
Slide control handles (11) off shaft.
11.
For transmission control head assembly, using screwdriver remove screws (12) holding detent plate (13).
12.
Remove screw (14), spring (15) and ball (16).
3-65
|
||
|
||
