| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
Using 11 mm open end wrench, hold retainer nut (8) and unscrew engine stop control handle (7) at console.
4.
Using 11 mm open end wrench remove small retainer nut (8) from cable end.
5.
Using two 9/16 inch open end wrenches remove outer retaining nut (9) from cable end.
6.
Push cable end through console.
7.
Using 9/16 inch open end wrench remove nut (10) and washer (11) from cable end.
8.
INSTALL:
Butt ends of old cable (12) and new cable (13) at injection pump. Wire cable ends together securely using 18 gage
1.
wire.
2.
Pull new cable (13) into position at console.
Remove old cable (12) from new cable (13).
3.
Using 9/16 inch open end wrench reinstall retaining nut (10) and inner washer (11) to cable end.
4.
Push cable through console as far as inner retaining nut (10) will allow.
5.
Using two 9/16 inch open end wrenches reinstall outer retaining nut (9) on cable end.
6.
Using 11 mm open end wrench reinstall small retainer nut (8) on cable end.
7.
Screw on engine stop control handle (7) at console while holding retainer nut (8) with 11 mm wrench.
8.
9.
Push engine stop control handle (7) fully against console.
3-85
|
||
|
||
