| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
NOTE
Switch can be removed without removing instrument panel.
1.
Remove wire leads (13) by pulling push-on connectors loose from switch using pliers.
2.
Hold switch on back side of panel and remove locking nut (14) using 16 mm wrench.
3.
Remove switch (15) from panel (16).
REPLACE: Switch
1.
Insert switch (15) into panel (16) from back side.
2.
Hold switch (15) in proper position and install locking nut (14) on switch (15) finger tight.
3.
Tighten locking nut (14) using 16 mm wrench while holding switch in position on back side of
panel.
4.
Reconnect two wire leads (13) by pushing connectors onto terminals using pliers.
REINSTALL: Instrument Panel
1.
Position panel (2) in opening on console.
2.
Secure panel (2) with six screws (1) using cross tip screwdriver.
3-101
|
||
|
||
