| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
REMOVE
1.
Drain engine cooling system (refer to paragraph 3-69.1).
2.
Disconnect hose (12) from header tank (1).
3.
Using 10 mm socket and ratchet, remove four screws (9) securing reservoir tank (10) to belt
guard (8). Remove reservoir tank (10) from belt guard (8).
4.
Remove belt guard (8) (refer to paragraph 3-119.1).
5.
Using 7/16-inch wrench, disconnect hoses (2), (4), and (5) from header tank (1).
6.
Using 9/16-inch wrench, disconnect hose (6) from elbow (3).
7.
Using 1/2-inch wrench, remove elbow (3) from header tank (1).
8.
Using flat tip screwdriver, loosen hose clamp (13) on header tank (1).
9.
Remove hose (14) and clamp (13) from header tank (1).
10.
Using 13 mm socket and ratchet, remove four screws (11) securing header tank (1) to engine (7).
11.
Remove header tank (1) from the engine (7).
INSTALL
1.
Apply pipe tape to coolant hoses (2), (4), and (5), and elbow (3).
2.
Using 13 mm socket and ratchet, install header tank (1) to engine (7) with four
screws (11). Tighten screws (11).
3.
Install belt guard (refer to paragraph 3-119.1).
4.
Using 7/16-inch wrench, install coolant hoses (2), (4), and (5) on header tank (1).
5.
Using 1/2-inch wrench, install elbow (3) on header tank (1)
6.
Using 9/16-inch wrench, install coolant hose (6) on elbow (3).
7.
Slide hose (14) and clamp (13) on header tank pipe beyond flare.
8.
Using flat tip screwdriver, tighten clamp (13) on header tank (1).
9.
Install hose (12) on header tank (1).
10.
Using 10 mm socket and ratchet, install reservoir tank (10) on beltguard (8) with four screws (9).
Tighten screws (9).
11.
Fill engine cooling system (refer to paragraph 3-69.1.)
12.
Close engine hatches.
13.
Close battery hatch.
3-158.1
Change 2
|
||
|
||
