| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
1.
Open control console access hatch (1) (refer to paragraph 3-154)
2.
Open map locker door (2).
3.
Reaching up inside the control console with both hands disconnect Shur terminals (3) from Shur connectors (4).
4.
Cut off Shur terminals (3) and discard.
Remove plastic spiral covering (5) and save.
5.
6.
Reach into map locker and using screwdriver remove two screws (6).
7.
Grasp map light (7) and pull out gently (drawing wires thru into the map locker).
REPLACE:
1.
Reaching into map locker while grasping map light (7), feed wires thru center hole of mounting Hock (8).
Place base of map light (7) against mounting block (8) alining holes in base with those in block.
2.
Using screwdriver install two screws (6).
3.
4.
Replace plastic spiral covering (5) on wire leads.
Using wire stripper, strip 1/4 inch of covering from end of each lead.
5.
6.
Place bare ends of wires into new Shur terminals (3) and crimp using crimping took.
7.
Using both hands connect Shur terminals (3) to Shur connectors (4).
8.
Close map locker door.
9.
Close control console access hatch.
3-216
|
||
|
||
