| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
NOTE
This figure illustrates the type of wires that are replaced, as separate wires.
Strip about 3/8 inch from end of wire using wire stripper.
5.
Measure replacement piece of wire and cut using wire cutter.
6.
Strip about 3/8 inch from both ends of replacement wire using wire stripper.
7.
Use crimper to crimp wire connector to each end of replacement wire only.
8.
Position replacement wire between ends of wire to be repaired and put end of wires into solderless connector.
9.
Use crimper to crimp wire connectors securing replacement wire to repaired wire.
10.
11.
Tape ends of connectors with electrical tape to insulate the connection.
12.
Reconnect batteries (refer to paragraph 3-89).
Close battery hatch (refer to paragraph 3-154).
13.
3-228
|
||
|
||
