| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
REMOVE
1.
Open and secure engine hatches (refer to paragraph 3-154)
2.
Remove engine breather (5), clamp (6), and plug (7) from adapter (8) by turning counterclockwise.
3.
Remove adapter (8) from plug (7).
4.
Using flat tip screwdriver remove clamp (12) and hose (9) from inlet (10).
5.
Using 13 mm wrench remove nut (3), washers (2), screw (13), and P-clamp (4) from bracket (14).
6.
Using 13 mm wrench remove screw (1) and bracket (14) from engine (11).
INSTALL:
1.
Using 13 mm wrench install screw (1) and bracket (14) on engine (11).
2.
Using 13 mm wrench install screw (13), washers (2), and nut (3) securing P-clamp (4), on
bracket (14). Do not tighten nut (3).
3.
Install hose (9) on inlet (10) with clamp (12).
4.
Using 13 mm wrench tighten nut (3) securing hose (9) in P-clamp (4)
5.
Apply thin coat of sealing compound to threads of adapter (8).
6.
Install adapter (8) and plug (7) on hose (9).
7.
Using flat tip screwdriver install clamp (6) securing engine breather (5) on plug (7).
8.
Close engine hatches.
Change 2
3-282.1
|
||
|
||
