| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
6.
Using 7/16 inch socket wrench remove three hex head screws, (4) and three washers (5) securing support plate (6).
7.
Remove pump assembly (7) and support plate (6) from boat as a unit.
Using 1/4 inch wrench, remove four screws (8), four washers (9) and support plate (6) from pump assembly (7).
8.
Remove and clean screen (10).
9.
INSTALL:
Aline pump assembly (7) to screen (10) and support plate (6). Insure screw holes are alined.
1.
Using 1/4 inch wrench reinstall four screws (8) and four washers (9) securing replacement bilge pump to support
2.
plate (6).
Position replacement bilge pump in sump location.
3.
Aline holes of support plate with holes in mounting bracket on boat.
4.
Secure support plate (6) and pump assembly (7) with three hex head screws (4) and three washers (5).
5.
Using 7/16 inch socket wrench, tighten three screws (4).
6.
7.
Connect bilge discharge hose (2) to pump and tighten hose clamp (3) with screwdriver.
8.
Connect and screw on motor electrical plug (1).
9.
Close engine hatch covers (refer to paragraph 3-154).
10.
Install aft cockpit (refer to paragraph 3-27).
11.
Close hydrojet hatch covers (refer to paragraph 3-154).
3-305
|
||
|
||
