Tweet |
Custom Search
|
|
|
||
TM 5-1940-277-20
TM 1940-20/2
REMOVE: (MK1 AFT COCKPIT AND DRIVE SHAFT COMPARTMENT SIDE - Block No. 41 thru 43)
1.
Remove aft cockpit (refer to paragraph 3-27).
2.
Lift two wedge blocks (3) out of position (refer to block placement diagram and to block placement cross-section
diagram) and place aside or discard as required.
Tilt block number (42) toward boat centerline and lift out and place aside or discard as required.
3.
4.
Slide remaining blocks either left or right, tilt toward centerline and lift out and set aside or discard as required.
INSTALL: (MK1 AFT COCKPIT AND DRIVE SHAFT COMPARTMENT SIDE - Block No. 41 thru 43)
1.
Clean area where blocks are to be installed.
2.
Install end blocks by inserting into center of mounting area and sliding blocks left or right (refer to block placement
diagram).
3.
Install key block (number 42).
4.
Install wedge blocks (3) (refer to block placement diagram cross-section).
5.
Install aft cockpit (refer to paragraph 3-27).
3-330
|
||