| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
Put one probe on plus (+) terminal/contact and one on the negative (-)
8.
Needle full right on scale, continuity through item is good.
9.
10.
Needle jumps back and forth, connection is bad or there is a short.
11.
Needle does not move from left position on scale, item has an open circuit (no continuity).
12.
To test electrical item or circuit for voltage, set multimeter to AC or DC volts position. (Set to a voltage higher than
operating voltage.)
13.
Connect batteries or source of voltage to the electrical system.
14.
Connect black probe to negative (-) terminal and red probe to positive (+) terminal.
15.
Read voltage on scale.
3-339
|
||
|
||
