| Tweet |
Custom Search
|
|
|
||
 TM 5-2010-205-14
NOTE
Make sure oil holes in rocker arm, rocker shaft, and bracket are clean
before reinstallation.
9.
Measure diameter of bore of bushing in rocker arm.
NOTE
The bore diameter must be between .8595 and .8611 inch. Replace
arm and bushing as a unit if bore is incorrect.
10. Measure diameter of shaft at each rocker arm location.
NOTE
Shaft diameter must be .8580 to .8588 inch or will be replaced.
11. Install screws (2) and nuts (1) onto rocker arm (7).
NOTE
Turn screws (2) until they are .44 inch below bottom of rocker arm
assembly.
12. Install rocker arm assemblies (7) and washers (8) onto shaft (4).
13. Install shaft assembly onto bracket (10).
NOTE
Adjustment screws must be on same side as oil hole on bottom of
bracket.
NOTE
Make sure that flat surfaces on shaft (4) are turned up.
14. Install locks (6), bolts (5) and washers.
15. Position rocker arm assembly on engine.
16. Adjust rocker arms and valves (steps 1 through 5).
17. Tighten bolts (3).
5-44
|
||
|
||
