| Tweet |
Custom Search
|
|
|
||
 TM 5-2010-205-14
3. Remove bolts (24) and washers (23) and remove fire extinguisher (22) and angle bracket (21).
4. Remove rear panel (25) by removing bolts (26).
5. Remove knob (19).
6. Remove nuts (13) and bolts (17) from bearings (16).
7. Remove bolts (20) from side panel (15).
8. Slide side panel (15) from main panel over lever arm (18).
9. Remove set screws (34) from collar (30) and pull lever (18) from assembly.
10. Remove cap (10), nut (9) and pull off steering wheel (11).
11. Disconnect all hoses from valve (12).
12. Remove bolts (14) and remove valve (12).
13. To remove gauges (1) typical, loosen and remove nut (3), slip off bracket (2), disconnect electric wire or hydraulic
hose and remove gauge (1).
14. Loosen and remove bolts (35), washers (36), and nuts (29).
15. Remove screws (28) from angle clips (27) and remove power inverter (38).
16. Loosen and remove bolts (32) and washers (31).
17. Remove servo (power steering) valve (33) from frame.
18. Install servo valve (33).
19. Install and tighten washer (31) and bolts (32).
20. Install power inverter (38).
21. Install angle clips (27) and screws (28).
22. Install and tighten washers (36), bolts (35) and nuts (29).
23. Reinstall gauges typically by installing bracket (2), tightening nut (3) and reconnecting electric wire or hydraulic hose.
24. Install valve (12).
25. Install and tighten bolts (14).
26. Connect hoses to valve (12).
5-58
|
||
|
||
