| Tweet |
Custom Search
|
|
|
||
 TM 5-2010-205-14
REPLACEMENT
5. Cover hose ends with tape or other material to prevent contamination.
6. Remove cotter pin (26).
7. Remove jam nut (25) and prop nut (24).
8. Remove propeller (23) using special puller tool and key (6).
9. Remove bolts (22) and rope guard/seal assembly (21). Use tapped back-off holes if necessary.
10. Remove seals (7) and (8) from seal housing (21).
11. Remove bolts (9) and lockwashers (10) from bearing housing (20).
12. Remove complete power module assembly from lower housing.
13. Remove bolts (28) and lockwasher (27). Pull assembly apart.
14. Remove bolts (18) and washers (17).
15. Remove O-ring (38).
16. Pull prop shaft (13) from assembly.
17. Remove bearing retaining ring (16), shims (15) and bearings (14), (outer race).
18. Press bearing (19) (inner race) off shaft.
19. Press bearing (12) (inner race) off shaft (13).
20. Tap bearing (11) (outer race) from housing (20).
21. Remove bolts (32) and lockwashers (31) from motor (33).
22. Remove bolts (30) and lockwashers (29) from flange (35) and gear (37).
23. Remove O-ring (34), and gasket (36).
24. Replace O-ring (34), and gasket (36).
25. Install bolts (30) and lockwashers (29) into flange (35) and gear (37).
26. Install lockwashers (31) and bolts (32) into motor (33).
27. Install bearing (11) (outer race) onto housing (20).
28. Press bearing (12) (inner race) onto shaft (13).
29. Press bearing (19) (inner race) onto shaft.
30.
31.
32.
33.
34.
35. 5-78
|
||
|
||
