| Tweet |
Custom Search
|
|
|
||
 TM 5-2010-205-14
2. Turn crankshaft until two pistons are at bottom center.
3. Remove connecting rod caps (2) from the two connecting rods.
NOTE
Put tape or other protection on threads of connecting rod bolts.
4. Push pistons and connecting rods away from crankshaft until piston rings are above the cylinder block.
5. Remove the pistons (1) and the connecting rods.
CAUTION
Do not turn crankshaft while any connecting rods are in the engine without the caps installed.
6. Do steps 2 through 5 for the remaining pistons.
7. Remove rings from the piston.
8. Remove bearings from connecting rod and the connecting rod cap.
9. Remove snap rings (3), pin (4) and connecting rod (5) from the piston.
10. Heat connecting rod to 350-500 degrees F.
11. Put 5P8654 spacer (10) in the base plate.
12. Put connecting rod on base plate.
13. Put connecting rod piston pin bearing end in the center of the port assembly.
14. Install pin (13) in the center of the bore for the connecting rod bearings.
15. Install 5P8653 adapter (8).
NOTE
Put the hole in the adapter in alignment with the hole in base plate.
16. Install clamp bar (11) and clamp pin (12).
17. Install new piston pin bearing on adapter (8).
6-35
|
||
|
||
