| Tweet |
Custom Search
|
|
|
||
 TM 5-2010-205-14
NOTE
The piston pin bearing joint must be in alignment with the hole in adapter (8) and the base plate.
19. Put pusher (6) on adapter (7).
20. Push new piston pin bearing into the connecting rod until adapter (7) makes full contact with connecting rod surface.
21. Remove connecting rod and old piston pin bearing.
22. Check piston pin bearing bore diameter (refer to inspection procedures this paragraph).
23. Install connecting rods (1), Figure 6-10 in the piston with the bearing tab groove on the opposite side of the hole
(crater) in top of piston.
NOTE
When old pistons are used, clean the piston grooves.
24. Install piston ring (2).
25. Install snap ring (1).
NOTE
The gap in the ring must be approximately 180 degrees from the oil ring connections.
26. Install the spring for the oil ring.
27. Install oil ring.
CAUTION
When connecting rod caps are installed, make sure that the number on the side of the cap is
next to and respective with the number on the side of the connecting rod.
6-37
|
||
|
||
