Figure 4-19. Removing the governor, hull number 8540 thru 8560 and 8580 thru 8618.

Custom Search

Figure 4-18. Removing the governor.

TM-55-1905-217-12 Landing Craft Mechanized; Steel; DED; Overait Length 74 Feet Mod 1 Marl VIII Navy Design LCM-8 Hull Numbers 8500 and 8580 thru 8618 Manual

Figure 4-20. Governor components.

TM 55-190-217-12

NOTE: PORT ENGINE INSTALLATION SHOWN.

ME 1905-217-12/4-19

Figure 4-19. Removing the governor, hull number 8540 thru 8560 and 8580 thru 8618.

(

(2) Place a new copper gasket on each weight

housing over the dowel pins in the weight housing.

housing to-blower bolt and thread the bolts into the

blower end plate, finger tight only.

NOTE

The finished surface of the operating fork must

(3) Place a new gasket over the dowels and the

be placed against 'the outer side of the thrust

side of the weight housing facing the

(4)

bearing.

Move the thrust 'bearing assembly and rise toward

the weight end of the shaft.

(6) Affix a new gasket to the governor control

housing; then attach the governor control housing to the

(5)

Position the lower end of the control

cylinder head with two bolts. Tighten the bolts.

4-24