| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-217-34
(2) If complete disassembly is planned, clean all paint and surface contamination from the unit at points of
separation. To clean the unit, first plug all four ports, then wire brush around the meter area and rinse and blow away all
surface contamination.
(3) Place the unit in vise, control end up. Clamp across port surface and opposite side of housing lightly. Remove
the two cap screws that fasten column to lower unit. Remove column and set aside. (Mark the two cap screw holes so
that the ports will be in the proper direction when reassembled).
(4) Clamp unit in vise across mounting plate (21, fig. 4-27) edges with meter end up. Remove 7 cap screws and
carefully lift the metering section from the unit.
4-42
|
||
|
||
