| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-217-34
Section IV. RAMP HOIST HYDRAULIC SYSTEM
4-15. General
Refer to the Operator and Organizational Maintenance Manual TM 55-1905-217-12 for descriptions of the ramp
hoist systems. Following paragraphs cover components used in two different systems-one group of components
for hull no. 8500 thru 8519 and the other components for hull number 8520 thru 8560 and 8580 thru 8619.
4-16. Winch-Hull Number 8500 thru 8519
a. General. Refer to Operational Maintenance Manual TM 55-1905-217-12 for description of this winch.
c. Disassembly. When removing components from the system, disconnect hydraulic lines, cap open ends,
and leave lines in place unless in need of replacement. Fittings may be left in components unless fittings are
damaged or components are to be replaced. Disassemble winch, gear reducer, and brake only to the extent
necessary to inspect for and repair or replace defective parts. When breaking hydraulic line connections, cap
all open line ends and ports.
(1) Winch. Refer to figure 4-38. Remove drum support (4) from base (1) and drum (3) and slide drum
from reduction gear output shaft.
4-55
|
||
|
||
