Custom Search
 
  
 
TM 55-1905-217-34
(f) Remove the seven nuts (8) and washers from the final drive end of the winch.
(g) For final housing with tapped puller holes in the flange, use two 1/2 inch N.C. x 2 inch cap
screws as jacks and pull the housing off the dowel bolts (6). For final housings with cast slots under the edge of
the flange, use two heel bars and remove the housing from the dowel bolts (6).
(2) Disassembly of primary drive assembly.
CAUTION
Do not remove this assembly as a unit as damage may be caused to the seal
diameter of the primary planet hub and the tapered seal diameter of the taper
seal ring on the sun gear shaft.
(a) Clean all dust and dirt away from the motor ports and vent port and disconnect the hydraulic
hoses. Mark the location of the spring cover (3, fig. 4-44) with respect to the housing (21) and location of
spring cover (3) with respect to the motor assembly (8), this will insure that the motor ports and vent port are
located correctly on reassembly.
4-65


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business