| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-5. MARINE GEAR MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL IN CRAFT (Cont)
6. Secure the manifold to the main housing
with sixteen 3/8-16 X 1-1/2 hex-head
cap screws (93). Tighten the cap
screws to 38 lb-ft (51.5 Nm) torque.
Install the three bolts that were
removed from the propeller flange and
the companion flange.
7. Install a new corprene ring gasket
(86) in the manifold (50). Install
the oil return pipe assembly (85) in
the manifold (50) and against the
gasket by indexing the return pipe on
the roll pin in the manifold (50).
8. Place the top cover plate (14) and a
new top cover plate gasket (15) in
position on the main housing, and
secure the cover plate to the housing
with ten 3/8-16 X 7/8 hex-head cap
screws (13). Secure the breather
chain clip in position beneath one of
the cap screws. Tighten the cap
screws to 38 lb-ft (51.5 Nm) torque.
9. Place the oil pump assembly (49), with
attached parts and a new oil-pump-to-
manifold gasket (51) in position
against the manifold, and secure the
oil pump to the manifold with four
3/8-16 X 1 hex-head cap screws (48).
Tighten the cap screws to 38 lb-ft
(51.5 Nm) torque. Connect the oil-sump-
to-strainer flexible hose (9) to the
oil strainer housing.
10. Place the selector valve assembly (60)
with attached parts and a new selector-
valve-to-manifold gasket (61) in
position against the manifold (50) and
secure the selector valve to the mani-
fold with two 3/8-16 X 2-3/4 hex-head
cap screws (58) and two 3/8-16 X 5-3/4
hex-head cap screws (59). Tighten the
cap screws to 38 lb-ft (51.5 Nm) torque.
5-160
|
||
|
||
