| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-7. VARIABLE SPEED MECHANICAL GOVERNOR - MAINTENANCE INSTRUCTIONS
(Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-REASSEMBLY (Cont.)
p. Connecting
1. Install.
link (68),
plain
2. Place the opposite
washer
end of the connecting
(67), and
link on top of the
spring
control link operating
retainer
lever and install the
(66)
connecting pin.
9. Governor
weight
and shaft
assembly
NOTE
If the governor weight carrier assembly was removed from the weight shaft, the
weights must be removed from the carrier before attempting to install the carrier
on the shaft.
a. Weight
1. Support the weight
carrier
carrier (rear face up)
(60)
on a sleeve and a
steel support (with a
1" hole) over an open-
ing in the bed of an
arbor press.
2. Lubricate the weight
shaft with engine oil.
Then, insert the non-
splined end of the
shaft through the
carrier, sleeve, and
hole in the steel
support. Bring the
ram of the press
down on the shaft
and press the shaft
straight into the
carrier until the
shoulder on the shaft
is tight against the
carrier.
5-202
|
||
|
||
