| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-8. BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-DISASSEMBLY (Cont.)
NOTE
A step under the shoulder of the installer will position the oil seal
approximately .005" below the finished face of the end plate. This is
within the .002" to .008" specified.
4. Install the remaining
oil seals in the end
plates in the same
manner.
b. Blower
1. The top of the end
front end
plate is readily
plate (58)
identified by the
three bolt holes and
one oil hole, where-
as the bottom side
of the end plate has
three bolt holes and
three oil holes.
Also, the dowel pins
(66 and 67) extend on
both sides of the front
end plate.
5-238
|
||
|
||
