| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-9. FUEL INJECTOR-MAINTENANCE INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-ASSEMBLY (Cont)
c.
Gear
Place on top of gear.
retainer
(13)
d. Bushing
Align the locating pin
(11)
in the bushing with the
slot in the injector
body, then slide the
end of the bushing into
place.
7. Spray tip,
a. Injector
Support bottom end up
spring
body (12)
in holding fixture.
cage, check
valve
b. Seal ring
Place on shoulder of
(16)
body.
c.
Spill
Place over barrel of
deflector
body.
(10)
d. Check
1. Place the check valve
valve (17),
(without the .010"
and check
hole) centrally on
valve cage
the top of the bushing.
(18)
2. Then place the check
valve cage over the
check valve and
against the bushing.
e. Spring
1. Insert the spring seat
seat (19),
in the valve spring,
spring
then insert the
(20), and
assembly into the
spring
spring cage, spring
cage (21)
seat first.
CAUTION
Install a new spring seat in a former injector if
a new design spray tip assembly is used.
5-280
|
||
|
||
