| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-35. BLOWER-MAINTENANCE INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL - DISASSEMBLY (Cont)
g. Screws
Remove six places.
(41), and
(42)
h. Bearing
Remove two places.
retainers
(43)
i.
Screws (44)
Remove.
j.
Screws (45)
Loosen.
Approximately
three turns.
k.
Rear end
1. Back out the center
Use two pullers
plate (46)
screws of pullers
J6270-1.
far enough to permit
the flange of each
puller to lay flat
on the end plate.
2. Align the holes in
each puller flange
with the tapped holes
in the end plate and
secure the pullers to
the end plate with six
1/4 inch -20 x 1-1/4
inch or longer screws.
NOTE
Be sure that the 1/4 inch -20 screws are threaded
all the way into the tapped holes in the end plate
to provide maximum anchorage for the pullers and
to eliminate possible damage to the end plate.
3. Turn the two puller
screws uniformly
clockwise and with-
draw the end plate
and bearings from
the blower housing
and rotors as shown
below.
5-558
|
||
|
||
