| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-65.2 DISCONNECT CLUTCH-ANCHOR WINCH-MAINTENANCE INSTRUCTIONS
(Continued)
LOCATION
ITEM
ACTION
REMARKS
ADJUSTMENT
CAUTION
Be sure hold-down screws are used to hold the springs
compressed and free the release levers before clutch is
assembled to the engine flywheel.
5. Release
Using straight edge and scale or suitable tool, set
levers
adjusting screws in the endsof the release levers
to (3/4 inch) "Dimension A" . "Dimension A" is the
distance from the ground surface on the raised
lever bosses of the clutch flywheel ring (cover) to
the heads of the lever adjusting screws when clutch
is bolted in engine flywheel and in the engaged
position. The contact points of these adjusting
screws should be set at a uniform distance from
the underside of the straight edge. The adjusting
screws must be in the same plane within 1/32 inch.
To change the position of the screws, loosen the
locknuts and turn the screw as required to obtain
"Dimension A". Be sure to tighten locks securely
after making screw adjustment.
5-848
|
||
|
||
